Wellcome to Max-Redline.com
    
Home       Browse Categories       About Us       Contact Us
92mm Billet Aluminum Throttle Body For GM LS1 LS2 LS3 LS6 LS7 LSX

  • $90.00
  • Item Code: TB-LS-92
  • Availability: In Stock

    

0 reviews / Write a review

CXRacing 92mm Billet Aluminum Throttle Body For GM CAMARO FIREBIRD LS1 LS2 LS3 LS6 LS7 LSX

Bore Size-Back: 3.61"
Flow Rate: 1218 CFM

This New Billet Aluminum Throttle Body is Completely New Design. It is NOT an Universal TB, It is Specifically Designed For GM LSx Motor, with 92MM Throttle Opening.

It Fits Aftermarket Intake Manifold That is Bigger than Stock Size.Otherwise a Spacer is Needed to Be Able to Fully Open The Butterfly. (We Offer The Spacer Separately).
Direct Bolt on Fit Factory TPS Sensor. Unique Cable Adapter Design, Offer Many Ways of Connecting Throttle Cable. With 92mm Throttle Opening.

PROUDLY MADE IN USA
　
　
　
　
Highlights:
-CNC Cut Billet Aluminum Throttle Body for GM GEN III LSX
-CNC Cut Billet aluminum Throttle Body Housing, 92MM Single Blade
-Sealed Roller Bearings. Uses Stock TPS Sensor
-Stock Idle Control Valve Location
-Increase Horsepower with Aftermarket Turbo Setup, Faster Throttle Response
-Will Support High Horsepower Boosted Engines
　
Below Are Installation Pictures:::
　
　
　

　
　

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha
Emission Notes:

All Parts and services offered by Max-Redline are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. Max-Redline assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of Max-Redline products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.
Copyright © 2025 - Max-Redline.com - All rights reserved